Concept redesign by Bronxo Technologies for engenity. Official site: engenity.com
engenity, LLCDC-powered freeze prevention · Minneapolis, MN Toll-free(844) 288-2590

SoliStat keeps working in cold, water and electrical noise

Most bimetallic thermostats are not rated below 32°F (0°C). SoliStat is rated to operate from −40°F (−40°C) up to 257°F (125°C), and its sealed housing keeps out water and dust.

SoliStat test in the engenity lab temperature chamber reading −40.0 °C

Tested at both extremes

Two units ran at −40°F in a temperature chamber and at +257°F in an oven, each switching a heater at 10 A (on 0.5 s, off 2.0 s), for over 1,200,000 cycles. A third unit cycled from −40°F to +257°F every four hours for 36 hours and still switched normally.

Sealed against water and dust

The sealed nylon housing is rated IP67: dust-proof, and fine when splashed or submerged. In our lab a SoliStat ran fully submerged for 72 hours without a fault.

Protected against interference

Circuitry guards against electrostatic discharge beyond IEC 61000-4-2 Level 4, surges on engine startup, electromagnetic interference and counter-emf from heavy inductive loads such as large motors.

Temperature chamber held at −40 °C during cycle testing
Temperature chamber held at −40 °C during cycle testing
Cycle counter during the extreme-temperature test
Cycle counter during the extreme-temperature test
NASA's GROVER on the Greenland ice sheet
NASA's GROVER on the Greenland ice sheet

Proven in Greenland

NASA installed SoliStat on GROVER, an autonomous robot that worked at the peak of Greenland's ice sheet. It handled temperatures down to −22°F and harsh winds with normal function throughout. Read the GROVER case study.

Electrostatic discharge

Many thermostats leave their chips unguarded, so a burst of static during installation or operation can blow them. SoliStat's circuitry keeps ESD away from sensitive parts.

Counter-emf

Heavy inductive loads kick back a short reverse-polarity pulse at switch-off. The same construction that guards against ESD also shields SoliStat from it.

Common questions

How cold can SoliStat operate?

It is rated to operate down to −40°F (−40°C) and stored down to −76°F (−65°C).

Can it get wet?

Yes. It is rated IP67 and ran submerged for 72 hours in our lab test.

Is it protected against reverse polarity?

Not against long-term accidental reverse-polarity connection. If you need that, contact us or your distributor.

Get a quote: SoliStat: weatherproof and rugged

Prefer to talk? Toll-free (844) 288-2590, local (612) 767-9590. To order standard parts, go through a distributor.

  1. The part: component or hose manufacturer and model number, and length.
  2. Power: supply voltage and the current the heater or load draws.
  3. Temperatures and quantity: setpoints you need and how many.

Call toll-freeGet a quote